Aironet AP3500-E User's Guide download pdf (Page 17)

Installation

2- 3

Installing the Ethernet Connection

The Aironet Access Point supports three connection types:

•

10Base2 (Thinnet)

•

10Base5 (Thicknet) AUI connector

•

10BaseT (Twisted Pair)

To Attach 10Base2 (Thinnet) Cabling:

1. Make sure the unit is powered off.

2. Attach the Thinnet cabling to each end of a BNC

T-connector, if applicable.

3. Attach the T-connector to the 10Base2 BNC. If the

AP3500-E is at the end of the Ethernet cable, a

50-Ohm terminator must be installed on the open end of

the T-connector.

CAUTION: Removing a terminator to install extra cable, or

breaking an existing cable to install a T-connector, will

cause a disruption in Ethernet traffic. Consult with your LAN

administrator before you change any Ethernet cabling

connections.

10Base2

10Base5

10BaseT

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 26 27

No comments

Aironet AP3500-E User's Guide Page 17